Product Center
Rotary (screw) air compressor oil S8
Product Introduction
This product is based on polyalphaolefin as the base oil, added with high-performance ashless composite additives, and blended using advanced production processes. It is a high-quality fully synthetic air compressor lubricating oil that can provide good protection for rotary compressors under extreme loads and temperatures.
Product advantages
Excellent thermal stability and oxidation stability. Under extremely harsh operating conditions, it can effectively suppress the formation of sludge and carbon deposits, and prolong the oil change cycle.
Adapt to a wider range of usage temperatures. Can be used for higher exhaust temperatures; At low temperatures, it can ensure smooth equipment startup.
Good wear resistance and high load-bearing capacity can effectively reduce equipment wear and prolong its service life.
Excellent air release and anti foaming properties, as well as good oil and gas separation performance, can ensure the system operates without faults and improve system efficiency.
Typical Data
ITEM | L-DAH（XH）32 | L-DAH（XH）46 | TEST METHOD |
Kinematic viscosity(40℃)/(mm2/s) | 32.05 | 46.21 | GB/T 265 |
Viscosity index | 137 | 135 | GB/T 1995 |
Pour point/℃ | -54 | -54 | GB/T 3535 |
Flash point (opening)/℃ | 248 | 255 | GB/T 3536 |
Copper corrosion (100 ℃, 3h)/level | 1a | 1a | GB/T 5096 |
Anti emulsification (40-37-3)/min, 54 ℃ | 5 | 5 | GB/T 7305 |
Anti foaming properties, ml/ml Program I (24 ℃) Program II (93.5 ℃) Program III (Post 24 ℃) | 0/0 10/0 0/0 | 0/0 10/0 0/0 | GB/T 12579 |
scope of application
Mainly recommended for rotary screw and blade air compressors.
Do not use for lubrication of compressed oxygen, ammonia, chlorine, and other acidic gas air compressors.
precautions
According to the regulations for equipment oil, select oil with appropriate quality and viscosity levels; Storage containers must be dedicated, and during storage and transportation, they must be waterproof, moisture-proof, and prevent mechanical impurities from entering; Prevent foreign object contamination; Prevent mixing with other oil products.
On site maintenance personnel need to regularly check the lubricating oil level: when the compressor is unloaded, the lubricating oil level is around 1/5 of the window; When the compressor is loaded, the lubricating oil level is between 1/2 and 3/4 of the sight window. Too little lubricating oil can cause high exhaust temperature of the compressor, but too much can increase the consumption of lubricating oil, not only wasting lubricating oil, but also affecting the stable operation of the unit.
When the air filter element, sealing gasket, oil filter, oil and gas separator and other accessories cannot meet the usage requirements, they should be replaced in a timely manner, and the use of low-quality three filters is strictly prohibited. Replace spare parts on time and do not reuse them.
According to the air humidity conditions, the equipment should be regularly drained. Water and oil will form an emulsion, which will greatly reduce the adhesion of lubricating oil and is not conducive to the lubrication of the equipment.
The oil change cycle of screw air compressor oil depends on the quality of the inhaled air, working cycle, working environment, and equipment maintenance. If the environment is very harsh (such as high dust and humidity), it is recommended to shorten the oil change cycle appropriately. For specific oil change cycles, please consult with Taihang sales representatives.